< Previous   Next >

2013 - CX-5 - Body and Accessories

FRONT DOOR MODULE PANEL REMOVAL/INSTALLATION

1. Perform the front door glass preparation. (See FRONT DOOR GLASS REMOVAL/INSTALLATION.)
2. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0].)
3. Remove the following parts:
a. Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION.)
b. Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION.)
c. Front door speaker (See FRONT DOOR SPEAKER REMOVAL/INSTALLATION.)
d. Front door glass (See FRONT DOOR GLASS REMOVAL/INSTALLATION.)

NOTE:

4. Remove bolt A.

5. Detach front door wiring harness securing clips B, C, D and E.
6. Disconnect the connectors shown in the figure.

7. Remove screws F.

8. Remove screw G.
9. Remove fastener H.
10. Pull the front door module panel in the direction of arrow (1) shown in the figure and remove the protector and pin from the front door inner panel.

CAUTION:

11. Move the front door module panel in the direction of arrow (2) shown in the figure so that the upper part of the front power window regulator does not contact the front door inner panel, and remove the front door module panel and the front power window regulator as a single unit.

12. Remove the front power window motor. (See POWER WINDOW MOTOR REMOVAL/INSTALLATION.)
13. Remove the front power window regulator. (See FRONT POWER WINDOW REGULATOR REMOVAL/INSTALLATION.)
14. Install in the reverse order of removal.


< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.